skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing front exhaust pipe > < Adjust accelerator control

Octavia Mk1

Removing and installing parts of the exhaust system
Removing and installing parts of the exhaust system
  Note
t  Always replace gaskets and self-locking nuts.
t  Use a screwdriver to slacken and tighten the clamps of the heat shield. Tightening torque: 2 Nm
1 - Tunnel bridge
–  with hole for aligning exhaust system → Chapter
2 - Hanger
–  Fitting position → Fig.
3 - 25 Nm
4 - Front exhaust pipe
–  pay attention to different version
–  with oxidation catalytic converter
–  with separation point
–  protect against shocks and blows
–  Avoid a large deflection, max. deflection 10°
–  removing and installing → Chapter
5 - 40 Nm
–  replace
–  coat with hot bolt paste -G 052 112 A3-
6 - Gasket
–  replace
7 - Exhaust manifold
–  removing and installing → Chapter
8 - 25 Nm
–  replace
–  coat with hot bolt paste -G 052 112 A3-
9 - Washer
10 - Lambda probe, 50 Nm
–  coat only thread with hot bolt paste -G 052 112 A3-; hot bolt paste must not get into the slot of the probe body
–  test: → 1.6 ltr./74 kW Motor, Simos 2 Injection and ignition system; Rep. Gr. 24
–  Plug connection for lambda probe is located below the protective cover → Anchor
11 - Clamping sleeve
–  Align exhaust system free of stress before tightening → Chapter
–  Fitting position: synchronous running to vehicle floor, bolted connection pointing to left
–  Tighten bolted connections evenly
12 - 40 Nm
13 - Hanger
14 - Front and rear silencer
–  Replace individually when carrying out repairs → Chapter
–  Align exhaust system free of stress → Chapter
  S26-0132
Installed position of the hanger
The angled side -arrow- at the base of the hanger points in direction of travel.
  A26-0128

Removing and installing front exhaust pipe > < Adjust accelerator control