Octavia Mk1
| Removing and installing sealing flange and flywheel |
Note| t | Repairing the clutch → Manual Gearbox 02M; Rep. Gr.30 → Manual Gearbox 02J; Rep. Gr.30. |
| t | The engine should be attached with engine mount -MP 1-202- and spacer bushes -T30010- to the assembly stand -MP 9-101- for carrying out removal and installation operations. |
| 1 - | Gasket ring |
| q | Do not apply additional oil to sealing lips |
| q | before inserting remove oil residues on crankshaft journal with a clean cloth |
| q | replace the gasket ring for the crankshaft - on the belt pulley side → Chapter |
| 2 - | Front sealing flange |
| q | must be positioned on dowel sleeves |
| q | removing and installing → Chapter |
| q | install with silicone sealant -D 176 404 A2 - |
| 3 - | Cylinder block |
| q | removing and installing crankshaft → Chapter |
| q | Disassembling and assembling piston and conrod → Chapter |
| 4 - | The two-mass flywheel |
| q | removing and installing → Chapter |
| 5 - | 60 Nm + torque a further 90° (1/4 turn) |
| q | replace |
| q | tightening may occur in successive stages |
| 6 - | Intermediate plate |
| q | must be positioned on dowel sleeves |
| q | do not damage/bend during assembly work |
| q | attached to sealing flange → Fig. |
| 7 - | 15 Nm |
| 8 - | Rear sealing flange |
| q | with gasket |
| q | must be replaced completely |
| q | Do not appy additional oil to sealing lip of gasket ring |
| q | before inserting remove oil residues on crankshaft journal with a clean cloth |
| q | slip onto the crankshaft out of the assembly set to install the guide sleeve |
| q | guide sleeve must not be removed until after pushing sealing flange onto the crankshaft journal |
| q | to remove and install, take off oil pan → Chapter |
|
|
