Octavia Mk1
| Vehicles with front-wheel drive |
| 1 - | Fuel tank |
| q | when removing, support e.g. with the engine/gearbox jack -V.A.G 1383 A - |
| q | removing and installing → Chapter |
| 2 - | Gasket ring |
| q | replace if damaged |
| q | to be inserted dry into the opening of the fuel tank |
| q | only moisten from the inside the flange of the fuel pump with fuel for fitting purposes |
| 3 - | Fuel pump -G6- |
| q | with sender for fuel gauge display -G - |
| q | note the installed position of the fuel tank → Fig. |
| q | removing and installing → Chapter |
| q | inspecting fuel pump → Chapter |
| q | removing and installing fuel gauge sensor → Chapter |
| 4 - | Union nut, 80 Nm |
| q | use wrench -MP 1-227- for removing and installing |
| q | check for firm seating |
| 5 - | Feed line |
| q | to fuel filter |
| q | clipped in place on fuel tank |
| q | check for firm seating |
| q | black |
| 6 - | Return-flow line |
| q | from fuel cooler |
| q | clipped in place on fuel tank |
| q | check for firm seating |
| q | blue |
| 7 - | Overflow hose |
| 8 - | O-ring |
| 9 - | Gravity valve |
| q | to remove, unclip valve and lift up and out of the filler neck |
| q | inspect valve for blockage, valve in a vertical position: open, valve tilted 45°: closed |
| 10 - | Cap |
| q | replace the O-ring if it is damaged |
| 11 - | Rubber bowl |
| q | fastened with tensioning ring |
| 12 - | Earth connection |
| 13 - | O-rings |
| 14 - | Vent valve |
| q | check → Fig. |
| 15 - | 10 Nm |
| 16 - | Ventilation hose |
| 17 - | Circlip |
| q | removing: turn left |
| q | Installing: tighten to 2 Nm |
| 18 - | Heat shield |
| q | for fuel tank |
| 19 - | Cover |
| q | for fuel tank |
| q | not fitted to all vehicles |
| 20 - | 20 Nm + torque a further 90° (1/4 turn) |
| q | replace |
| 21 - | Tensioning strap |
| q | pay attention to different lengths |
| 22 - | Fuel cooler |
| q | removing and installing → Chapter |
| 23 - | to fuel filter |
| 24 - | 20 Nm |
|
|
|
|
