Octavia Mk1
| Summary of components of oil filter holder |
| 1 - | Oil pressure switch - F1- - 20 Nm |
| q | 0.07 MPa (0.7 bar) switch |
| q | Cut open gasket ring if leaking and replace |
| q | check → Chapter |
| 2 - | Gasket |
| q | replace |
| 3 - | 15 Nm + torque a further 90° (1/4 turn) |
| q | replace |
| q | first of all set up the bolt at the top left and the bottom right and then tighten all four bolts cross-wise |
| 4 - | Oil filter holder |
| q | with oil retaining valve |
| q | the oil retaining valve cannot be replaced individually |
| 5 - | Gasket ring |
| q | replace |
| 6 - | Oil feed line |
| q | to turbocharger |
| 7 - | Hollow screw - 25 Nm |
| 8 - | Screw cap - 25 Nm |
| q | release and tighten with wrench for oil filter - 3417- |
| 9 - | O-ring |
| q | replace |
| 10 - | Oil filter element |
| q | Check fitting position: marking “TOP” faces up |
| q | pay attention to change intervals → Octavia |
| 11 - | Oil cooler |
| q | ensure clearance to surrounding components |
| q | Pay attention to the information regarding a necessary replacement → Anchor |
| q | connection diagram for coolant hoses → Chapter |
| 12 - | Screw plug - 25 Nm |
| 13 - | Gasket |
| q | replace |
| 14 - | Gasket |
| q | replace |
| q | push into the grooves on the oil cooler |
| 15 - | Screw plug - 10 Nm |
| q | Cut open gasket ring if leaking and replace |
| 16 - | Screw plug |
| q | for oil retaining valve |
| q | do not slacken |
