–
| Remove crankshaft timing belt sprocket. To this end lock the toothed belt gear with counterholder -T30004- or counterholder -MP1-310-. |
Note When screwing on the counterholder -MP1-310- place 2 washers between the toothed belt gear and the counterholder. |
–
| Unscrew the screws of the sealing flange. |
–
| Remove sealing flange, if necessary release by applying slight blows with a rubber-headed hammer. |
WARNING Wear protective googles and gloves when working with sealant and grease remover! |
|
–
| Remove old sealant from the cylinder block, oil pan and sealing flange with chemical sealant remover. |
–
| Degrease the sealing surfaces. They must be free of oil and grease. |
|
|
|