Octavia Mk1
| Summary of components |
Note| t | The following illustration shows the V-ribbed belt of vehicles not fitted with the air conditioning. |
| t | Mark the rotation direction before removing the V-ribbed belt. Reversing the rotation direction of an already used belt may destroy it. |
| t | Pay attention to the correct position of the V-ribbed belt in the belt pulley when installing it. |
| 1 - | V-ribbed belt |
| q | before removing mark running direction |
| q | do not kink |
| q | check for wear |
| q | routing of ribbed V-belt on vehicles without air conditioning → Fig. |
| q | routing of ribbed V-belt on vehicles with air conditioning → Fig. |
| q | removing → Chapter |
| q | installing → Chapter |
| 2 - | 10 Nm + torque a further 90° (1/4 turn) |
| q | replace |
| 3 - | Belt pulley |
| q | with vibration damper |
| q | Assembly only possible in one position - holes offset |
| 4 - | 25 Nm |
| 5 - | Tensioning device for ribbed V-belt |
| q | with roller |
| q | after releasing, secure e.g. with a 3 mm hexagonal wrench. |
| 6 - | Generator |
| q | removing and installing → Electrical System → Rep. Gr.27 |
| q | push in threaded bushes for fixing bolts slightly in order to more easily position the alternator against the compact holder |
| 7 - | Compact holder |
| q | for alternator, hydraulic pump and AC compressor |
| q | Fitting sleeve → Fig. |
| 8 - | 45 Nm |
| q | insert using locking agent |
| q | order of tightening → Fig. |
| 9 - | Hollow screw, 45 Nm |
| 10 - | Gasket ring |
| q | replace |
| 11 - | Pressure line |
| 12 - | The vane pump for the power-assisted steering |
| q | removing and installing → Chassis → Rep. Gr.48 |
| 13 - | Belt pulley |
| q | for the vane pump on the power-assisted steering |
|
|
|
|
|
|
|
|
