skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the rain sensor > < Replacing spray nozzle (Octavia)

Octavia Mk1

Removing and installing wiper rubber
Removing and installing wiper rubber
Removing
   
–  Use combination pliers to compress both steel rails at the closed side of the wiper rubber, take them out of the top clip to the side and pull rubber complete with rail out of the remaining clips of the wiper blade.
Install
–  Fit new wiper rubber into the bottom clips of the wiper blade.
–  Insert both steel rails into the first groove of the wiper rubber so that the recesses of the rails point towards the rubber and lock into the rubber lugs of the groove.
  S92-0017
–  Use combination pliers to again compress both steel rails and rubber and insert into the top clip so that the lugs of the clip on both sides engage in the retaining slots -arrow- of the wiper rubber.
  S92-0018

Removing and installing the rain sensor > < Replacing spray nozzle (Octavia)