Octavia Mk1
| Summary of components - bearing of shank bevel gear |
| 1) Adjustments need to be made when replacing these parts → Chapter. |
| 1 - | Twelve-point nut for shank bevel gear |
| q | unscrew → Anchor |
| q | screw on → Anchor |
| q | insert using locking agent -D 154 000 A1- |
| 2 - | Inner ring/taper roller bearing, small1) |
| q | removing → Anchor |
| q | installing → Anchor |
| 3 - | Outer ring/taper roller bearing, small1) |
| q | pressing out → Anchor |
| q | installing → Anchor |
| q | insert using locking agent -D 154 000 A1- |
| 4 - | Secondary shaft housing1) |
| q | removing and installing → Chapter |
| q | Check hole at secondary shaft housing for oil leakage → Fig. |
| 5 - | Gasket rings |
| q | for shank bevel gear |
| q | removing → Anchor |
| q | assemble → Anchor |
| q | insert in the fitting position → Anchor |
| q | inserting → Anchor |
| 6 - | Outer ring/taper roller bearing, large1) |
| q | pressing out → Anchor |
| q | installing → Anchor |
| q | insert using locking agent -D 154 000 A1- |
| 7 - | Inner ring/taper roller bearing, large1) |
| q | remove → Anchor |
| q | pressing on → Anchor |
| 8 - | Distance sleeve |
| q | absolutely replace → Electronic Catalogue of Original Parts |
| 9 - | Shank bevel gear1) |
| q | is paired with head bevel gear |
| q | according to gearbox identification characters assign via the → Electronic Catalogue of Original Parts. |
| q | Clean thread to remove locking agent |
|
|
