skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

Overview of fitting locations - engines with identification characters AVU, BFQ > < For vehicles ? 07.97
For vehicles 08.97 ►
For vehicles 08.97 ►
Engines with identification characters AEH, AKL
The component A is not shown on the overview figure.
   
A - Clutch pedal switch -F36-
q   in footwell on the clutch pedal
1 - 3-pin plug
q   for hall sender -G40-
q   black
2 - Hall sender -G40-
q   under top toothed belt guard
3 - Lambda probe -G39-
q   with heating for lambda probe -Z19-
q   Engine with identification characters AEH: fitting location of catalytic converter
q   Engine with identification characters AKL: fitting location of exhaust manifold (illustration)
4 - 4-pin plug
q   for lambda probe and heating for lambda probe
q   on the driver side below a cover
5 - Valve for variable intake manifold changeover -N156-
6 - Engine control unit-J361-
q   replace → Chapter
7 - Throttle valve control unit -J338-
8 - Air mass meter -G70- with intake air temperature sender -G42-
9 - Coolant temperature sender -G62-
10 - Earth connection
q   at the gearbox
11 - 3-pin plug
q   for knock sensor 1 -G61-
12 - Ignition coils -N- and -N128- with power output stage -N122-
13 - Engine speed sender -G28-
14 - 3-pin plug
q   for engine speed sender -G28-
q   grey
15 - Knock sensor 1 -G61-
16 - Injection valves (-N30...N33-)
17 - Fuel pressure regulator
18 - PAS pressure switch -F88-
19 - Activated charcoal filter
20 - Activated charcoal filter system solenoid valve 1 -N80-

   

Overview of fitting locations - engines with identification characters AVU, BFQ > < For vehicles ? 07.97