Test intake manifold changeover |
Special tools and workshop equipment required |
t
| Hand vacuum pump, e.g. -VAS 6213- or -V.A.G 1390- |
Note Observe all safety measures and notes for assembly work on the fuel, injection and ignition system as well as the rules for cleanliness → Chapter. |
The test should only be carried out if there is a problem with poor torque, i.e. if insufficient elasticity or poor pulling power exists. |
If the intake manifold valve -N316- is o.k., perform the following tests: |
–
| Remove engine cover with air filter and lay aside → Chapter. The plug should not be disconnected from the intake air temperature sender 2 -G299- while doing this. |
–
| Start engine and run in idle. |
|
|
|