skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Enginecrankshaft group, pistons > < Check setting

Octavia Mk2

Adjusting the unit mounting
Adjusting the unit mounting
Special tools and workshop equipment required
t  Supporting device -T30099-
t  Shim -T30099/1-
t  Adapter -MP9-200/3 (10-222A/3)-
t  Lifting eye -10-222A/12-
t  Snap hook
–  Remove battery and battery tray → Electrical System; Rep. Gr.27.
   
–  Install supporting device -T30099- and support engine in fitting position.
–  Uniformly pre-tension the engine/gearbox unit with both spindles, but do not raise.
  S10-0391
–  Release the screws -arrows- of the assembly bracket at the engine.
  A10-1898
–  Slightly loosen the screws -arrows- of the assembly bracket at the gearbox (less than 1 revolution).
–  Successively replace all the screws (as long as it has not already been performed when installing the engine) and insert these loosely.
  A10-1634
–  Move the engine/gearbox assembly with an assembly lever between engine support -1- and supporting arm -3- for engine mount until the following dimensions are set:
l  Both bolt heads -2- must be positioned parallel to the edge of the supporting arm -3- for engine mount.
l  Between engine bracket -1- and engine support -4- there must be a distance -x- = 10 mm.
  Note
The distance -x- can be checked e.g. with suitable round bars.
–  Tighten the screws for the engine side assembly bracket → Chapter.
  A10-1808
–  Make sure that on the gearbox side the edges of the supporting arm -2- and gearbox support -1- are parallel.
l  The dimension -x- must be the same on both mount sides.
–  Tighten the screws for the gearbox side assembly bracket → Chapter.
Installation is carried out in the reverse order.
  A10-1662

Enginecrankshaft group, pistons > < Check setting