Octavia Mk2
Exhaust gas system - Summary of components, vehicles with front-wheel-drive (BLR, BVY) |
1 - | 25 Nm |
q | replace |
q | Coat pin screws of exhaust manifold with hot bolt paste -G 052 112 A3- |
2 - | Lambda probe downstream of catalytic converter -G130-, 55 Nm |
q | Colour of the plug: black |
q | the thread of new lambda probes must be coated with assembly paste |
q | for re-used lambda probe, only coat the thread with hot bolt paste -G 052 112 A3-; the hot bolt paste -G 052 112 A3- must not get into the slots of the probe body |
3 - | Lambda probe 2 downstream of catalytic converter -G131-, 55 Nm |
q | Colour of the plug: brown |
q | the thread of new lambda probes must be coated with assembly paste |
q | for re-used lambda probe, only coat the thread with hot bolt paste -G 052 112 A3-; the hot bolt paste -G 052 112 A3- must not get into the slots of the probe body |
4 - | Front part of exhaust system |
q | with catalytic converter |
q | protect against shocks and blows |
q | with decoupling element |
q | do not twist decoupling element more than 10° - risk of damage |
q | removing and installing → Chapter |
q | Align exhaust system free of stress → Chapter |
5 - | Lambda probe 3 downstream of catalytic converter -G287-, 55 Nm |
q | Colour of the plug: black |
q | only coat the thread with hot bolt paste -G 052 112 A3-; the paste must not get into the slots of the probe body |
6 - | Retaining strap |
q | replace if damaged |
7 - | Rear tunnel bridge |
8 - | 20 Nm |
9 - | Rear part of exhaust system |
q | for first equipment building unit with the middle part of the exhaust gas system, replace individually when carrying out repairs |
q | Align exhaust system free of stress → Chapter |
q | Separate the exhaust system → Chapter |
10 - | Hanger |
q | replace if damaged |
11 - | 23 Nm |
12 - | Rear clamping sleeve |
q | for individually replacing the front and rear silencer |
q | Fitting position → Chapter |
q | Tighten screwed connections uniformly |
13 - | 23 Nm |
14 - | 20 Nm |
15 - | Front tunnel bridge |
16 - | Middle part of exhaust system |
q | for first equipment building unit with the rear part of the exhaust gas system, replace individually when carrying out repairs |
q | Align exhaust system free of stress → Chapter |
q | Separate the exhaust system → Chapter |
17 - | Front clamping sleeve |
q | align exhaust system free of stress before tightening → Chapter |
q | Fitting position → Chapter |
q | Tighten screwed connections uniformly |
18 - | 23 Nm |
19 - | Hanger |
20 - | Hanger |
q | replace if damaged |
21 - | Gasket |
q | replace |