| Mounting sequence - removing and installing gearbox housing cover and 5th/6th gear |
Note | t
| If it is intended to only remove the 5th/6th gear, keep to the following work sequence. |
| t
| If it is intended to remove the gearbox housing, this work sequence must be observed: completely disassembling and assembling the gearbox → Chapter. |
| Special tools and workshop equipment required |
| t
| Drive bushing -MP3-402 (VW 244 B)- |
| t
| Supporting bridge -MP3-425 (30-211 A)- |
| t
| Pressure washer -MP3-456 (VW 447 i)- |
| t
| Insertion tool -MP3-466 (32-111)- |
| t
| Thrust plate -MP3-467 (40 - 105)- |
| t
| Pipe section -MP3-4012 (VW 416 B)- |
| t
| Assembly device -MP6-414 (3253)- |
| t
| Assembly stand -MP 9-101- |
| t
| Assembly device -T10030- |
| t
| Supporting bridge -T10323- |
| t
| Gearbox mount -T30109 (VW 353)- |
| t
| Two-arm extractor -Kukko 20/10 - with extraction hook -T10040/2A - |
| t
| Hot air blower e.g. -V.A.G 1416- |
| t
| Sealant -AMV 188 200 03- |
|
|
|
