skoda Workshop Repair Guides

Skoda Octavia Workshop Service and Repair Manuals

ABOUT US
Setting multi-function switchF125 > < Removing, installing and setting multi-function switchF125

Removing and installing multi-function switchF125 for Octavia Mk2 gearbox

Removing and installing the multi-function switchF125
Removing and installing the multi-function switch -F125-
Removing
–  Shift selector lever to position „N“.
–  Switch off ignition.
–  Remove air filter → Engine; Rep. gr.24.
   
–  Lever off the selector lever control cable -1- from the gearshift lever -6-, e.g using an open-end wrench, while ensuring that the selector lever control cable does not get kinked.
  Note
Do not release screw -2-.
–  Unplug connector -5- at multi-function switch.
  S37-0190
–  Remove gearshift lever -1-.
  S38-0033
–  Bend back the hooks of the circlip -2- using a screwdriver.
  Note
If one or several hooks of the circlip break off by bending, the circlip must be replaced → Electronic Catalogue of Original Parts.
–  Remove nut -3- with washers -2- and -1-.
–  Unscrew the 2 screws -B- and pull off the multi-function switch -A- upwards over the gearshift shaft.
Install
Installation is carried out in the reverse order. Pay attention to the following:
–  Fit the multi-function switch -F125- onto the gearshift shaft.
–  Tighten the fixing screws -B- for multi-function switch by hand.
–  Fit washers -1-, -2- and nut -3- onto the gearshift shaft.
  S38-0034
–  Secure the nut by bending up the hooks to the circlip -2-.
  Note
If one or several hooks of the circlip break off by bending, the circlip must be replaced → Electronic Catalogue of Original Parts.
–  Setting multi-function switch -F125- → Chapter.
  S38-0034
–  Install gearshift lever -1-.
  Note
The gearbox must remain in the position „N“, if necessary shift back into „N“.
  S38-0033
–  The plug -5- is placed onto the multi-function switch.
–  Push selector lever control cable -1- onto the gearshift lever -6-, while ensuring that the selector lever control cable does not get kinked.
  Note
Under some circumstances the gearshift lever must be shifted in the correct position, in order to be able to push on the selector lever control cable.
–  Inspect setting of selector lever control cable → Chapter.
Tightening torques
  S37-0190
ComponentNm
Multi-function switch -F125- to gearshift shaft7
Gearbox shift lever to gearshift shaft13

   

Setting multi-function switchF125 > < Removing, installing and setting multi-function switchF125