Octavia Mk2
| Ignition system - Summary of components |
| 1 - | Cable guide |
| 2 - | 8 Nm |
| 3 - | Cap |
| 4 - | Connector |
| 5 - | Hall sender -G40- |
| 6 - | 10 Nm |
| 7 - | Ignition cable with spark plug connector |
| q | Remove the spark plug connector from the spark plugs using the extractor -T10112 A-. |
| t | D ignition transformer = ignition cable cyl. 1 |
| t | B ignition transformer = ignition cable cyl. 2 |
| t | C ignition transformer = ignition cable cyl. 3 |
| t | A ignition transformer = ignition cable cyl. 4 |
| 8 - | Spark plug, 25 Nm |
Note| t | When installing new spark plugs, the spark plug connectors must be regreased with lubricating paste -G 052 141 A2-. In doing so, the sealing hose of the spark plug connector does not stick to the spark plug. The lubricating paste must spread over the spark plug when fitting on the spark plug connector → Fig.. |
| t | The new spark plug cables are supplied greased. |
| 9 - | Knock sensor 1 -G61- |
| q | at rear cylinder block |
| q | 20 Nm |
| 10 - | Connector |
| 11 - | 20 Nm |
| q | the tightening torque influences the knock sensor function |
| 12 - | Ignition transformer -N152- |
| t | D ignition transformer = ignition cable cyl. 1 |
| t | B ignition transformer = ignition cable cyl. 2 |
| t | C ignition transformer = ignition cable cyl. 3 |
| t | A ignition transformer = ignition cable cyl. 4 |
| 13 - | Engine speed sender -G28- |
| q | removing and installing → Chapter |
| 14 - | 5 Nm |
| 15 - | 7 Nm |
