Octavia Mk2
| Lubrication system - Summary of components |
| 1 - | 15 Nm |
| 2 - | Support |
| q | for wiring loom of oil level and oil temperature sender |
| 3 - | Pressure relief valve, 27 Nm |
| q | Opening pressure: 0.13...0.16 MPa (1.3...1.6 bar) overpressure |
| q | is mounted in the engines with identification characters BGU |
| 4 - | Oil injection nozzle |
| q | for cooling pistons |
| q | is mounted in the engines with identification characters BGU |
| 5 - | Dipstick |
| q | Oil level must not exceed the max. marking! |
| 6 - | Filler funnel |
| q | Remove for extracting oil |
| 7 - | Guide tube |
| 8 - | Dowel sleeves |
| q | 2 pieces |
| 9 - | O-ring |
| q | replace |
| 10 - | Suction line |
| q | Clean strainer if dirty |
| 11 - | Baffle |
| 12 - | Oil pan |
| q | removing and installing → Chapter |
| q | with oil level and oil temperature sender -G266- |
| 13 - | Sealing ring |
| q | replace |
| 14 - | Oil drain plug, 30 Nm |
| 15 - | 10 Nm |
| q | self-locking, replace |
| 16 - | Oil level and oil temperature sender -G 266- |
| 17 - | Sealing ring |
| q | replace |
| q | oil before the assembly |
| 18 - | Oil pump |
| q | with pressure relief valve 1.2 MPa (12 bar) |
| q | before installing, check whether both dowel sleeves Pos. 8 for centering the oil pump/cylinder block are present |
| q | if there is any scoring on contact surfaces and gears, replace |
| q | removing and installing → Chapter |
| 19 - | Oil pump sprocket |
| q | Fits onto oil pump shaft in one position only |
| 20 - | 20 Nm + torque a further 90° (1/4 turn) |
| q | replace |
| 21 - | Oil pump chain |
| q | before removing mark running direction |
| q | check for wear |
| 22 - | Front sealing flange |
| q | removing and installing → Chapter |
| q | install with silicone sealant |
| q | Replace crankshaft seal on belt pulley side → Chapter |
| 23 - | Chain tensioner, 15 Nm |
| q | do not disassemble |
| q | Check fitting position |
| q | When installing, pretension spring and attach |
|
|
