Octavia Mk2
| Oil filter holder - Summary of components |
| 1 - | O-ring |
| q | replace |
| q | push on as far as collar on the tube → Item |
| q | is mounted in the engines with identification characters BGU |
| 2 - | Pipe |
| q | for crankcase ventilation |
| q | is mounted in the engines with identification characters BGU |
| 3 - | To vent housing under the cap |
| 4 - | Spring strap clamp |
| q | is mounted in the engines with identification characters BGU |
| 5 - | Retaining clip |
| q | is mounted in the engines with identification characters BGU |
| 6 - | Screw plug, 15 Nm |
| 7 - | Sealing ring |
| q | cut open if leaking and replace |
| 8 - | 0.14 MPa (1.4 bar) oil pressure switch -F1-, 25 Nm |
| q | black insulation |
| q | check → Chapter |
| 9 - | Sealing ring |
| q | cut open if leaking and replace |
| 10 - | Oil filter holder |
| q | with pressure relief valve approx. 0.4 MPa (4 bar) |
| 11 - | 15 Nm + torque a further 90° (1/4 turn) |
| q | replace |
| 12 - | Gasket |
| q | replace |
| q | fit into the grooves on the engine oil cooler |
| q | is mounted in the engines with identification characters BGU |
| 13 - | Engine oil cooler |
| q | pay attention to the notes → Chapter |
| q | ensure clearance to surrounding components |
| q | Connection diagram for coolant hoses → Chapter. |
| q | is mounted in the engines with identification characters BGU |
| 14 - | 25 Nm |
| 15 - | Oil filter |
| q | slacken with tensioning strap |
| q | tighten by hand |
| q | pay attention to installation instructions on oil filter |
| 16 - | Screw plug, 40 Nm |
| 17 - | Sealing ring |
| q | replace |
| 18 - | Spring |
| 19 - | Piston |
| 20 - | Gasket |
| q | replace |
|
|
