skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Vehicles manufactured as of 09.09 > < Replacing camshaft gasket ring

Octavia Mk2

Vehicles manufactured up to 08.09
Vehicles manufactured up to 08.09
Special tools and workshop equipment required
t  Insertion tool -MP 1-214 (10-203)-
t  Gasket ring extractor -T30003 (3240)-
t  Screw M12x1.5x75 from insertion tool -MP 1-214 (10-203)-
Removing
–  Pull toothed belt off camshaft sprocket and from toothed belt gear on the high pressure pump → Chapter.
–  Remove camshaft sprocket and hub → Chapter.
   
–  Insert thrust piece -3240/1- into the camshaft.
–  Turn inner part of gasket ring extractor -3240- 2 turns (approx. 3 mm) out of the outer part and lock with knurled screw.
  A15-10683
–  Oil the thread head of the gasket ring extractor, position and forcely screw into the gasket ring as far as possible.
–  Release knurled screw and turn the inner side against the camshaft until the gasket ring is pulled out.
Install
  Note
The sealing lip of this gasket ring must be neither oiled nor greased.
  N15-0273
–  Fit guide bushing made out of -MP 1-214 (10-203)- on the camshaft as shown in the illustration.
–  Carefully slide the gasket ring -1- over the guide bushing onto the camshaft.
  A15-10684
–  Push on the sealing ring with the pressure plate of the insertion tool -MP 1-214 (10-203)- and press in screw M12x1.5x75 up to the stop.
–  Install the hub and the camshaft sprocket → Chapter.
–  Installing the timing belt → Chapter.
  N15-0274

Vehicles manufactured as of 09.09 > < Replacing camshaft gasket ring