skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing > < Removing and installing the drive shaft, output shaft, differential gear, shift mechanism and gearshift forks

Roomster

Mounting sequence
Mounting sequence
Removing and installing cover for gearbox housing, clutch housing, gearshift shaft with gearshift cover, drive shaft, output shaft, differential gear and gearshift mechanism
  Note
On gearboxes as of production date 06.09, the springs of the sliding sleeve with synchronizer body for 3rd, 4th and 5th gear are changed (the springs are longer), at the same time the synchronizer ring for 3rd and 4th gear is changed as of this date → Electronic Catalogue of Original Parts.
Special tools and workshop equipment required
t  Assembly stand -MP9-101-
t  Pressure plate -MP3-406 (VW 401)-
t  Pressure plate -MP3-407 (VW 402)-
t  Pressure spindle -MP3-408 (VW 412)-
t  Guide bolt -T10079-
t  Gearbox mount -T30012 (3221)-
t  Insert base -T10083-
t  Washer -T10083/1-
t  Thrust piece -T10085-
t  Sealant -AMV 188 200 03-
Change gearbox holder -T30012-
   
Drill a new hole in the gearbox holder -T30012 (3221)- to attach the Gearbox 02T.
Dimensions in mm.
–  Drill a hole Ø 11.0 mm -arrow-.
  A34-0292

Removing > < Removing and installing the drive shaft, output shaft, differential gear, shift mechanism and gearshift forks