| Replacing needle bearing for two-mass flywheel |
| Only on vehicles with manual gearbox. |
| Special tools and workshop equipment required |
| t
| Interior extractor -Kukko 21/2- |
| t
| Countersupport -Kukko 22/1- |
| t
| Mandrel -T30083 (3264)- |
Note | When installing the engine on vehicles with manual gearbox, check whether the needle bearing is built into the two-mass flywheel. Install the needle bearing as required. |
| –
| Pull the needle bearing out of the two-mass flywheel using the interior extractor with countersupport, e.g. Kukko 21/2 and Kukko 22/1. |
| Fitting position of the needle bearing: |
| t
| The marked side of the needle bearing must point to the crankshaft. |
| –
| Drive in using a mandrel -T30083 (3264)- |
| Depth of installation of the needle bearing: |
| t
| Dimension of the flywheel contact surface a = 24.5 ± 0.25 mm. |
|
|
|
