Yeti
Summary of components for electro-mechanical steering gear LHD - assembly carrier made of steel sheet |
1 - | Universal joint |
2 - | Screw, 30 Nm |
q | M8 x 35 |
q | replace after each removal |
3 - | Electrical line |
4 - | Power-steering gear |
q | The 3rd generation power-assisted steering |
q | with power-assisted steering control unit -J500- |
q | The steering angle sender -G85- is integrated in the steering gear and cannot be replaced separately |
q | check in the targeted fault finding → Vehicle diagnostic tester |
q | adapt the steering angle sender -G85- after each removal → Vehicle diagnostic tester |
q | adapt the power-assisted steering control unit -J500- after installing a new power-steering gear → Vehicle diagnostic tester |
5 - | Wheel-bearing housing |
6 - | Nut, 20 Nm + 90° |
q | self-locking |
q | replace after each removal |
7 - | Assembly carrier made of steel sheet |
8 - | Screw, 50 Nm + 90° |
q | M10 x 76 |
q | replace after each removal |
9 - | Heat shield |
10 - | Screw, 6 Nm |