skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the left temperature flap control motorV158 > < Left-hand drive

Yeti

Right-hand drive
Right-hand drive
–  Removing the dash panel → Body Work; Rep. gr.70.
–  Remove right footwell vent.
   
–  Unscrew screws -3- and nuts -1- (10 Nm) and remove the right support -2-.
  N87-10206
–  Unplug connector -C-.
–  Unscrew screws -A- (only two screws on right-hand drive vehicles) and remove control motor -B-.
–  Slacken the lever -E- from the coupling rod -D-.
Install
Installation is performed in the reverse order, pay attention to the following points:
  Note
t  After installing the control motor, it is necessary to test the operation of the defroster flap.
t  Carry out „Initiate basic setting“ with the → Vehicle diagnostic tester.
  A87-0710

Removing and installing the left temperature flap control motorV158 > < Left-hand drive