skoda Workshop Repair Guides

Skoda Yeti Workshop and Repair Manuals

ABOUT US
Right-hand drive > < Removing and installing the defroster flap control motorV107

Removing and installing defroster flap control motorV107 - Left-hand drive

Left-hand drive
Left-hand drive
Removing
–  Removing the dash panel → Body Work; Rep. gr.70.
–  Remove left footwell vent.
–  Remove data bus diagnostic interface control unit -J533- → Electrical System; Rep. gr.97.
   
–  Unscrew screws -3- and nuts -1- (10 Nm) and remove the support -2-.
  N87-10206
–  Unplug connector -C-.
–  Unscrew screws -A- and remove control motor -B-.
–  Slacken the lever -E- from the coupling rod -D-.
Install
Installation is performed in the reverse order, pay attention to the following points:
  Note
t  After installing the control motor, it is necessary to test the operation of the defroster flap.
t  Carry out „Initiate basic setting“ with the → Vehicle diagnostic tester.
  A87-0710

Right-hand drive > < Removing and installing the defroster flap control motorV107