skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing angle gearbox > < Removing the oil pan

Yeti

Installing the oil pan
Installing the oil pan
Installation is carried out in the reverse order. Pay attention to the following:
   
–  Replace both O-rings -arrows- at the connection of the mechatronics → Electronic Catalogue of Original Parts.
–  Moisten O-rings with DSG oil.
–  Clean sealing surfaces and eliminate residues of oil.
–  Pay attention to correct fitting of new oil pan gasket.
–  Position oil pan. At the same time do not get the cables trapped.
–  Insert new screws for the oil pan and tighten crosswise in several stages to tightening torque → Chapter.
  S34-0915
–  Mount the plug -A- of the mechatronics as follows:
l  The arrows -D- on the mechatronics -B- and on the plug -A- as well as the peg -C- must be on the same line and point upwards.
l  Then mount the plug -A- carefully up to the stop and lock the cap by turning it to the right in -direction of arrow-.
–  Replace gearbox oil filter (instructions, when the gearbox oil filter must be replaced and when not → Chapter).
–  Pour in gear oil → Chapter
  Note
If the battery earth strap is disconnected and connected, carry out certain additional operations → Electrical System; Rep. gr.27.
–  Connect earth strap of battery → Electrical System; Rep. gr.27.
  S34-1174

Removing and installing angle gearbox > < Removing the oil pan