Skoda Workshop Service and Repair Manuals

Install –  Slightly oil new gasket ring before installing on the outside diameter and between the sealing lips with high efficiency oil for Haldex coupling.

–  Drive in new gasket ring with pressure plate -T10019- up to the stop. Do not tilt the gasket ring during this process. –  Drive in flange for Haldex coupling.

–  Insert new hexagon nut with locking agent -D 000 600- and tighten. -A- Screw M10 x 25 -B- Allen screw M8 x 15 (is screwed in from the reverse side into the counterholder -T30004-) –  Install propshaft to final drive → Chapter.

–  Tighten the pendulum support with »new« screws -screws B and C- at the gearbox. Tightening torques → Engine; Rep. gr.10. –  Align intermediate bearing free of stress and tighten. Tightening torque → Chapter.

For vehicles Superb II –  Install the heat shield below the propshaft. For vehicles Octavia II and Yeti

When screwing the heat shield -2- with the intermediate bearing make sure that the screws -1- are within the four centering tabs. For all vehicles –  Install rear left vehicle level sensor -G76- → Chassis; Rep. gr.42. –  Install exhaust system and align free of stress → Engine; Rep. gr.26. –  Check oil level in the Haldex coupling → Chapter –  Install the noise insulation → Body Work; Rep. gr.50.

Tightening torques

Component	Nm
Haldex coupling to rear final drive1)	210
Flexible disk at propshaft („two-piece“ propshaft)	→ Chapter
Propshaft („one-piece“) on rear final drive (Octavia II and Yeti)	→ Chapter
Propshaft („one-piece“) on rear final drive (Superb II)	→ Chapter

1) Always replace nut → Electronic Catalogue of Original Parts.