Mounting sequence - Removing and installing gearbox housing cover and 5th gear |
Note t
| If it is intended to only remove the 5th gear, keep to the following work sequence. |
t
| For this work sequence, the gear oil must not be drained. Once the cover is removed, then the cover side of the gearbox must point upwards. |
t
| If it is intended to remove the gearbox housing, this work sequence must be observed: completely disassembling and assembling the gearbox → Chapter. |
Special tools and workshop equipment required |
t
| Drive bushing -MP3-402 (VW 244 B)- |
t
| Supporting bridge -MP3-425 (30-211 A)- |
t
| Pressure washer -MP3-456 (VW 447 i)- |
t
| Insertion tool -MP3-466 (32-111)- |
t
| Assembly device -MP6-414 (3253)- |
t
| Assembly stand -MP9-101- |
t
| Assembly device -T10030- |
t
| Supporting bridge -T10323- |
t
| Gearbox mount -T30109 (VW 353)- |
t
| Two-arm extractor -Kukko 20/10- with hook -T10040/2A+/3- |
t
| Hot air blower e.g. -V.A.G 1416- |
|
|
|