Yeti
| V-ribbed belt drive - Summary of components |
| 1 - | V-ribbed belt |
| q | mark the direction of rotation with chalk or a felt-tip pen before removing |
| q | check for wear |
| q | do not kink |
| q | removing and installing → Chapter |
| 2 - | 150 Nm + torque a further 180° (1/2 turn) |
| q | replace |
| q | removing and installing → Chapter „Removing and installing crankshaft-belt pulley“ |
| q | The clamping surface of the fixing screw must be free of grease and oil. |
| q | insert oiled (thread) |
| q | Secure belt pulley with counterholder -T30004 (3415)- to prevent it from turning |
| 3 - | Crankshaft-belt pulley |
| q | Clamping surfaces must be free of oil and grease. |
| 4 - | Bushing |
| q | Clamping surfaces must be free of oil and grease. |
| 5 - | O-ring |
| q | replace |
| 6 - | Guide pulley, 40 Nm |
| 7 - | 20 Nm |
| q | When loosening and tightening, counterhold with the wrench for the water pump and power-assisted steering -MP 1-308 (V.A.G 1590)- to this end rework wrench for the water pump and power-assisted steering - MP 1-308 (V.A.G 1590)- → Chapter |
| 8 - | Belt pulley for coolant pump |
| q | removing and installing → Chapter |
| 9 - | 9 Nm |
| 10 - | Coolant pump |
| q | removing and installing → Chapter |
| 11 - | 25 Nm |
| 12 - | Generator |
| q | removing and installing → Electrical System; Rep. gr.27 |
| q | to facilitate positioning, drive the threaded bushings for the screws at the generator slightly backwards |
| 13 - | 40 Nm + torque a further 90° (1/4 turn) |
| q | replace |
| 14 - | 25 Nm |
| 15 - | Bracket for auxiliary units |
| q | for tensioning device and AC compressor |
| q | removing and installing → Chapter |
| 16 - | Tensioning device for V-ribbed belt |
| q | swivel tensioning device for V-ribbed belt with wrench to slacken the V-ribbed belt |
| q | Secure tensioning device with a 4 mm hexagon wrench |
| q | to remove, release screw (-Pos. 11-) |
| 17 - | AC compressor |
| q | removing and installing → Heating, Air Conditioning; Rep. gr.87 |
| 18 - | 25 Nm |
| 19 - | Fitting sleeve |
| 20 - | Sealing ring |
| q | replace → Chapter |
