–
| Unscrew exhaust gas temperature sender 1 -G235- (temperature sender upstream turbocharger -G507-) -1- from the exhaust manifold. |
Installation is performed in the reverse order, pay attention to the following points: |
Note t
| The thread of the new temperature sender must be coated with assembly paste. |
t
| Grease only the thread with hot bolt paste -G 052 112 A3- for re-used temperature sender. |
t
| All cable straps should be fastened again in the same place when installing. |
Fitting position of the exhaust gas temperature sender 1 -G235- (temperature sender upstream turbocharger -G507 -): |
|
|
|