skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing lever key of switch mounting on the steering column > < Removing and installing switch mounting on the steering column

Yeti

Removing and installing restoring ring with coil springF350
Removing and installing restoring ring with coil spring -F350-
Removing
–  Removing steering column electronics control unit -J527- → Chapter.
   
–  Carefully release catch pegs -arrows- and pull off restoring ring with coil spring -1- from the switch mounting on the steering column.
Install
Installation is performed in the reverse order, pay attention to the following points:
  Note
When assembling, the restoring ring with coil spring must be in the centre position and the wheels in the straightahead position. In case of doubt about the correct positioning of the ring rotor, the middle position of the restoring ring must be set before installing the steering wheel → Chapter.
  S94-0187

Removing and installing lever key of switch mounting on the steering column > < Removing and installing switch mounting on the steering column