Baja F4-2.5L SOHC (2003)
7. Draw out the spring pin, and then remove the bushing A from gear shift lever.
ASSEMBLY
1. Clean all parts before assembly.
2. Mount the bushing and cushion rubber on the stay.
3. Mount each part; boot, O-ring, bushing A, spacer, bushing B. bushing and spring pin on the gear shift lever.
NOTE:
^
Always use new O-rings.
^
Apply grease [SUNLIGHT 2 (Part No.003602010 or equivalent] to the inner and side surfaces of the bushing when installing the spacer.
4. Insert the gear shift lever into boot hole.