Impreza 2.5 RS Coupe AWD F4-2.5L SOHC (2001)
Tightening torque: 5.4 Nm (0.55 kgf-m, 4.0 ft. lbs.)
7. Connect pipes A and B to four pipe joints of gearbox. Connect upper pipe B first, and lower pipe A second.
Tightening torque: 13 Nm (1.3 kgf-m, 9.4 ft. lbs.)
8. Install jack-up plate.
9. Connect battery minus terminal.
10. Feed the specified fluid and discharge air.
CAUTION: Never start the engine before feeding the fluid; otherwise vane pump might be seized up.
11. Finally check clearance between pipes and/or hoses, as shown. If clearance between cruise control pump and power steering hose is less than 10
mm (0.39 inch), proceed as follows:
1. Move clamped section (A) (refer to figure) down to a point where pipe is close to crossmember (pipe-to-crossmember clearance: 10 mm (0.39
inch), min.).
2. Check that clearance between cruise control pump and power steering hose is at least 10 mm (0.39 inch). If it is not, bend section (B) down
until a clearance of at least 10 mm (0.39 inch) is obtained.
INSPECTION
