Impreza 2.5 RS Sedan AWD F4-2.5L SOHC (2002)
2. Apply a coat of specified power steering fluid to the inner wall of valve housing.
3. Attach ST2 to ST1, and press the oil seal into the place using a press.
ST1 34099FA120 INSTALLER & REMOVER SEAL
ST2 34099FA130 INSTALLER SEAL
1. Face oil seal in the direction shown in figure when installing.
2. To avoid scratching oil seal, apply a coat of grease to the contact surface of installer and oil seal.
3. To facilitate installation, attach oil seal to the installer and position in valve housing before pressing into place.
4. Using ST and press, install the special bearing in valve housing.
ST 34099FA120 INSTALLER & REMOVER SEAL
NOTE: To facilitate installation, attach the ball bearing to the remover and position in valve housing before pressing it into place.
5. Put vinyl tape around pinion shaft splines to protect oil seal from damage.
6. Fit pinion and valve assembly into valve housing.
7. Secure valve assembly to ST1 and ST2.
