Impreza GT F4-2.5L Turbo (2009)
15) Install the steering wheel.
Tightening torque:
39 Nm (4.0 kgf-m, 28.8 ft-lb)
16) Install the airbag module to the steering wheel.
WARNING:
Always refer to "Airbag System" before performing the service operation.
17) Connect the ground cable to battery.
CAUTION:
After completion of installation, adjust the following two positions.
-
Positioning to the center of steering angle sensor
-
Positioning the yaw rate & G sensors to zero
The above procedure is required for the VDCCM to identify vehicle position afterward. For the setting procedures of the 2 steps above, refer
to "VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)".
