Impreza GT F4-2.5L Turbo (2009)
Clutch Release Fork: Service and Repair
Release Bearing and Lever
REMOVAL
1) Remove the transmission assembly from vehicle body.
2) Remove the two clips from the release lever and remove the release bearing. (Non-turbo model)
CAUTION:
Be careful not to deform the clips.
3) Remove the release bearing from the release lever. (Turbo model)
4) Remove the dust cover.
5) Remove the lever spring from the pivot with a screwdriver by accessing it through the clutch housing release lever hole. Then remove the release
lever.
INSTALLATION
NOTE:
Apply the specified grease to lubricate to the following points before installation.
^
Contact surface of lever and pivot
^
Contact surface of lever and bearing
^
Transmission main shaft spline (Use grease containing molybdenum disulfide.)
1) Apply grease (KOPR-KOTE: Part No. 003603001) to the contact point of the release lever and operating cylinder.
2) While pushing the release lever to the pivot and twisting it to both sides, fit the lever spring onto the raised portion of the pivot. (Non-turbo model)
