Impreza WRX STI F4-2.5L DOHC Turbo (2007)
Tightening torque:
95 Nm (9.7 kgf-m, 70.1 ft. lbs.)
(4) Transverse link rear bushing and body
Tightening torque:
250 Nm (25.5 kgf-m, 184 ft. lbs.)
NOTE:
Move the rear bushing back and forth until transverse link-to-rear bushing clearance is established (as indicated in the figure) before tightening.
6) Check the wheel alignment and adjust if necessary.
DISASSEMBLY
FRONT BUSHING
Using the ST, press the front bushing out of place.
ST 927680000 INSTALLER & REMOVER SET
REAR BUSHING
1) Scribe an aligning mark on the transverse link and rear bushing.
2) Loosen the nut, and then remove the rear bushing.
ASSEMBLY
FRONT BUSHING
Assemble in the reverse order of disassembly.
CAUTION: Install the front bushing in correct direction, as shown in the figure.
