Impreza WRX STI F4-2.5L DOHC Turbo (2007)
9) Place the PTJ boot at the center of shaft.
10) Align the alignment marks, and then install the trunnion on shaft.
11) Install the snap ring to shaft.
CAUTION:
Confirm that the snap ring is completely fitted in shaft groove.
12) Fill 100 to 110 g (3.53 to 3.88 ounces) of specified grease into the interior of PTJ outer race.
13) Apply a coat of specified grease to roller kit and trunnion.
14) Align the alignment marks on roller kit and trunnion, and then install the free ring.
CAUTION:
Be careful with the roller kit position.
15) Align the alignment marks on shaft and outer race, and then install the outer race.
16) Install the circlip in the groove on PTJ outer race.
CAUTION:
Pull the shaft lightly and assure the circlip is completely fitted in groove.
17) Apply an even coat of the specified grease 30 to 40 g (1.06 to 1.41 ounces) to the entire inner surface of boot.
18) Install the PTJ boot taking care not to twist it.
CAUTION:
^
PTJ installation surface of PTJ boot shall be cleaned so as to be free from grease and other substances.
^
When installing the PTJ boot, position the outer race of PTJ at center of its travel.
