Legacy Brighton Wagon AWD F4-2.2L SOHC (1997)
13) Finally check clearance between pipes and/or hoses, as shown above.
If clearance between cruise control pump and power steering hose is less than 10 mm (0.39 in), proceed as follows:
(1) Move clamped section (A) (refer to figure above.) down to a point where pipe is close to crossmember.
Pipe-to-crossmember clearance:
10 mm (0.39 in), mm.
(2) Check that clearance between cruise control pump and power steering hose is at least 10 mm (0.39 in). If it is not, bend section (B) down
until a clearance of at least 10 mm (0.39 in) is obtained.
2. RHD MODEL
1) Interconnect pipes C and D.
Tightening torque:
Joint nut
15 ± 5 Nm (1.5 ± 0.5 kg-m, 10.8 ± 3.6 ft-Ib)
CAUTION: Visually check that hose between tank and pipe D is free from bending or twisting.
2) Connect pipe D from oil tank.
3) Connect pipe C from oil pump.
CAUTION: Use a new gasket.
Tightening torque:
34 ± 5 Nm (3.5 ± 0.5 kg-m, 25.3 ± 3.6 ft-Ib)
4) Tighten bolt A.