Legacy Brighton Wagon AWD F4-2.2L SOHC (1997)
Mainshaft: Service and Repair
Drive Pinion Assembly
Disassembly
DRIVE PINION SHAFT
1. Straighten lock nut at staked portion. Remove the lock nut using Special Tool (ST1), ST2 and ST3. ST1 899884100 Holder, ST2 498427100
Stopper or ST3 899988608 Socket Wrench, or equivalent.
2. Withdraw drive pinion from driven shaft. Remove differential bevel gear sleeve (1), adjusting washer No. 1 (2) (25 x 37.5 x 1), adjusting washer
No. 2 (3) (25 x 37.5 x4), thrust bearing (4) (25 x37.5 x 3), needle bearing (5) (25 x 30 x 20), drive pinion collar (6), needle bearing (7) (30 x 37 x
23) and thrust bearing (8) (33 x 50 x 3).
3. Remove roller bearing and washer (33 x 50 x 5) using ST and press. ST 498077000 Remover, or equivalent.
CAUTION: Do not reuse roller bearing.
DRIVEN GEAR ASSEMBLY
CAUTION: Attach a cloth to the end of driven shaft (on the frictional side of thrust needle bearing) during disassembly or reassembly to prevent
