Legacy Outback Ltd Sedan F4-2.5L SOHC (2000)
9. Remove ABSCM&H/U from engine compartment.
CAUTION:
^
ABSCM&H/U cannot be disassembled. Do not attempt to loosen bolts and nuts.
^
Do not drop or bump ABSCM&H/U.
^
Do not turn the ABSCM&H/U upside down or place it on its side.
^
Be careful to prevent foreign particles from getting into ABSCM&H/U.
^
Apply a coat of rust-preventive wax (Nippeco LT or GB) to bracket attaching bolt after tightening.
^
Do not pull harness when disconnecting connector.
B: INSPECTION
1. Check connected and fixed condition of connector.
2. Check specifications of the mark with ABSCM&H/U.
C: CHECKING THE HYDRAULIC UNIT ABS OPERATION
Checking The Hydraulic Unit ABS Operation By Pressure Gauge
1. Lift-up vehicle and remove wheels.
2. Disconnect the air bleeder screws from the FL and FR caliper bodies.
3. Connect two pressure gauges to the FL and FR caliper bodies.
CAUTION:
^
Pressure gauges used exclusively for brake fluid must be used.
^
Do not employ pressure gauge previously used for transmission since the piston seal is expanded which may lead to malfunction of the brake.
