Outback F4-2.5L SOHC (2005)
11. Put a new band through the clip and wind twice in alignment with band groove of boot.
12. Pinch the end of band with pliers. Hold the clip and tighten securely.
NOTE: When tightening boot, use care so that the air within the boot is appropriate.
13. Tighten the band using ST.
ST 925091000 BAND TIGHTENING TOOL
NOTE: Tighten the band until it cannot be moved by hand.
14. Tap on the clip with the punch provided at the end of ST.
ST 925091000 BAND TIGHTENING TOOL
CAUTION:
Tap to an extent that the boot underneath is not damaged.
15. Cut off the band with an allowance of about 10 mm (0.39 inch)left from the clip and bend this allowance over the clip.
CAUTION: Be careful so that the end of the band is in close contact with clip.
16. Extend and retract the PTJ to provide equal grease coating.
Rear Drive Shaft Assembly
Rear Drive Shaft
D: ASSEMBLY
NOTE: Use specified grease.
BJ side: NTG2218-M (Part No. 28395AG010)
EBJ side: NTG2218-M (Part No. 28395AG010)
DOJ side: NKG205 (Part No. 28495AG000)
1. Install the BJ or EBJ boot in specified position, and fill it with 60 to 70 g (2.12 to 2.47 oz.) of specified grease.
2. Place the DOJ boot at the center of shaft.
CAUTION: Be sure to wrap shaft splines with vinyl tape to prevent boot from scratches.
