Outback [Legacy] AWD F4-2.5L DOHC (1996)
Operational Guidelines Of The ABS Sequence Control With Select Monitor
1) Connect select monitor to data link connector beside driver's seat healer unit.
2) Turn ignition switch ON.
3) Put select monitor to ABS mode.
4) Press F D 1 ENT key.
5) The message shown in the figure is displayed.
6) The message shown in the figure is displayed as follows:
(1) When using the brake tester, depress brake pedal with braking force of 981 N (100 kg, 221 lb).
(2) When using the pressure gauge, depress brake pedal so as to make the pressure gauge indicate 3,432 kPa (35 kg/cm2, 498 psi).
CAUTION: Do not depress the clutch pedal
7) When the message shown in the figure is displayed, press ENT key.
8) Check points will be displayed on select monitor.
9) When ABS sequence control cannot be started (by system malfunction, etc.), the message shown in the figure will be displayed.
NOTE: Read the trouble codes. Repair faulty parts.
10)
After completion of ABS sequence control, turn ignition switch OFF.
Conditions For Completion Of ABS Sequence Control
When the following conditions develop, the ABS sequence control stops and ABS operation is returned to the normal control mode.
1) When the speed of at least one wheel reaches 10 km/h (6 MPH).
