Tribeca F6-3.6L (2008)
3) Remove the caliper lower bolt.
4) Raise the caliper body, and then move it toward vehicle center to separate it from the support.
5) Remove the support from housing.
NOTE: Remove the support only when replacing the rotor or support. It need not be removed when servicing the caliper body assembly.
6) Remove mud and foreign matter from the caliper body assembly and support.
CAUTION: Be careful not to allow foreign matter to enter the brake hose connector.
INSTALLATION
1) Apply a thin coat of Molykote M7439 (Part No. K0770YA000) to the support.
2) Install the support to the housing.
Tightening torque: 66 N-m (6.7 kgf-m, 48.7 ft-lb)
3) Apply a thin coat of Molykote M7439 (Part No. K0770YA000) to the pad clip.
4) Apply a thin coat of Molykote AS880N (Part No. K0777YA010) to the contact surface between the pad and shim.
