Tribeca F6-3.6L (2008)
Seat Belt Tensioner: Service and Repair
Pretensioner Connector
PROCEDURE
1. BUCKLE SWITCH
1. How to disconnect:
1. Move the slide lock (A) in the direction of arrow.
2. While holding the slide lock (A) in moved position, disconnect the connector.
CAUTION: When pulling the slide lock or disconnecting connector, be sure to hold the connector, not the harness.
2. How to connect:
Holding the connector (A), and push it in carefully until a clicking sound is heard.
CAUTION: Be sure to insert the connector in until it is locked. Then pull it gently to make sure that it is locked.
2. DRIVER'S AIRBAG MODULE, CURTAIN AIRBAG MODULE AND PRETENSIONER
1. How to disconnect:
1. Using a flat tip screwdriver, pry the push lock upward to unlock.
2. Pull and disconnect the connector from the driver's airbag module assembly or retractor assembly.
