Aerio L4-2.3L (2006)
Installation
Reverse removal procedure for installation noting the following.
-
Check that no foreign material is attached to sensor and ring (1).
-
Be sure to install wheel speed sensor (2) and its bolt at the correct (upper) position as shown in figure. Tighten sensor bolt (1) to specified torque.
Tightening torque
Sensor bolt (a): 23 Nm (2.3 kgf-m, 17.0 ft. lbs.)
CAUTION: Do not pull or twist wire harness more than necessary when installing rear wheel speed sensor.
-
Check that there is no clearance between sensor and knuckle.
Inspection
-
Check sensor for damage.
-
Check sensor for resistance and continuity.
Between both terminals of sensor 1.2 - 1.6 k Ohms at 20°C (68°F)
Between sensor terminal and sensor body
No continuity
If the check result is not as specified and any malcondition is found, replace.
