Aerio L4-2.3L (2006)
-
To avoid accidental deployment / activation, this work should be performed by no more than one person.
-
Since smoke is produced when air bag (inflator) module is deployed and pretensioner is activated, select well-ventilated area.
-
Air bag (inflator) module and seat belt pretensioner will immediately deploy / activate when 12 volts vehicle battery is connected to it. Wear safety
glasses throughout this entire deployment / activation and disposal procedure.
-
Wear suitable ear protection when deploying air bag (inflator) module / activating seat belt pretensioner. Also, advise those who are in area close
to deployment / activation site to wear suitable ear protection.
-
Do not deploy / activate two or more air bag system components (air bag (inflator) modules and seat belt pretensioners) at the same time.
-
Never connect deployment harness to any 12 volts vehicle battery before connecting deployment harness to air bag (inflator) module and seat belt
pretensioner. Deployment harness shall remain shorted and not be connected to 12 volts vehicle battery till you are ready to deploy air bag
(inflator) module or activate seat belt pretensioner.
Deployment / Activation Outside of Vehicle
When you intend to return the vehicle to service, deploy the air bag (inflator) module(s) or activate seat belt pretensioner(s) outside of the vehicle.
1. Turn ignition switch to LOCK position and remove key.
2. Wear safety glasses during this deployment / activation procedure.
3. Check that there is no open, short or damage in special tools (deployment harness (A), adapter cable (B) and adapter cable (C)). If any faulty is
found, do not use it and be sure to use new special tool.
Special Tool
(A): 09932-75031
(B): 09932-76510
(C): 09932-78332
NOTE: If connector of adapter cable (C) is damaged, replace it with spare connector (D).
For special tool (C) spare connector
Special Tool
(D): 09932-75410
4. Short two deployment harness leads (1) together by fully seating one banana plug into the other.
WARNING: Deployment harness (A) shall remain shorted and not be connected to 12 volts vehicle battery till you are ready to deploy
air bag module or activate seat belt pretensioner.
5. Remove air bag (inflator) module(s) or seat belt pretensioner(s) from vehicle referring to Driver Air Bag (Inflator) Module Removal and
Installation:Advanced Air Bag, Passenger Air Bag (Inflator) Module Removal and Installation:Advanced Air Bag, Side Air Bag (Inflator) Module
Removal and Installation:Advanced Air Bag or Front Seat Belt Removal and Installation.
