Aerio L4-2.3L (2006)
WARNING:
-
For handling and storage of seat belt pretensioner, select place where ambient temperature is below 65 degrees C (150 degrees F),
without high humidity and away from electric noise.
-
Never carry seat belt pretensioner by webbing.
-
When placing seat belt pretensioner on workbench or other surface, be sure to lay it with its exhaust hole (1) side facing up. It is also
prohibited to put something on seat belt pretensioner. Otherwise, personal injury may result.
6. Set air bag (inflator) module or seat belt pretensioner as follows.
a. For driver air bag (inflator) module
i.
Clear space (3) on ground about 185 cm (6 ft) in diameter where driver air bag (inflator) module (1) is set for deployment. Paved, outdoor
location where there is no activity is preferred. If outdoor location is not available, use space on shop floor where there is no activity and
sufficient ventilation is provided. Ensure no loose or flammable object exists within deployment area.
ii. Place driver air bag (inflator) module (1) with its vinyl trim cover facing up (2) on ground in step i).
b. For passenger air bag (inflator) module
i.
Clear space (3) on ground about 185 cm (6 ft) in diameter where passenger air bag (inflator) module (1) is set for deployment. Paved,
outdoor location where there is no activity is preferred. If outdoor location is not available, use space on shop floor where there is no
activity and sufficient ventilation is provided. Ensure no loose or flammable object exists within deployment area.
ii. Place deployment fixture (A) on ground in step i).
Special Tool
(A): 09932-75041
iii. Fill plastic reservoir in deployment fixture (A) with water or sand. This is necessary to provide sufficient stabilization of fixture during
deployment. iv) Attach passenger air bag (inflator) module (1) in deployment fixture (A) securely using M8 bolt (2).
CAUTION: Be sure to use M8 size and 7T strength bolt for fixing passenger air bag (inflator) module (1) to deployment fixture (A).
