Aerio L4-2.3L (2006)
iv. Attach passenger air bag (inflator) module (1) in deployment fixture (A) securely using M8 bolt (2).
CAUTION: Be sure to use M8 size and 7T strength bolt for fixing passenger air bag (inflator) module (1) to deployment fixture (A).
c. For side air bag (inflator) module
i.
Remove side air bag (inflator) module cover (1).
ii. Clear space (3) on ground about 185 cm (6 ft) in diameter where side air bag (inflator) module for deployment. Paved, outdoor location
where there is no activity is preferred. If outdoor location is not available, space on shop floor where there is no activity and provide
sufficient ventilation. Ensure no loose or flammable objects are within deployment area.
iii. Place deployment fixture (A) on ground in Step i).
Special Tool
(A): 09932-75041
iv. Fill plastic reservoir in deployment fixture (A) with water or sand. This is necessary to provide sufficient stabilization of fixture during
deployment.
v. Attach side air bag (inflator) module (1) in deployment fixture using mounting attachment, hold-down bolts & nuts and M8 bolt & nut (2).
NOTE: Make sure that deploying direction faces as shown in figure against mounting attachment.
CAUTION: Be sure to use M8 size and 7T strength bolt and nut for fixing side air bag (inflator) module to deployment fixture (A).
d. For seat belt pretensioner
i.
Cut webbing (1) at tongue plate stopper (3) of seat belt pretensioner (2) side as shown.
NOTE: Hold seat belt pretensioner (2) vertically in the same condition as it is installed. Otherwise, webbing can't be pulled out.
