Aerio L4-2.3L (2006)
1. Confirm that battery negative (-) cable is disconnected.
2. Turn ignition switch to LOCK position and remove key.
3. Connect yellow connector (1) of contact coil and combination switch assembly by pushing connector till clicks heard from it.
4. In case of passenger air bag (inflator) module, connect yellow connector (1) of passenger air bag (inflator) module by pushing connector till click
is heard from it.
5. Install glove box.
6. If equipped with side air bag (inflator) module, connect yellow connector (2) of side air bag (inflator) module by pushing connector till click is
heard from it.
7. Install AIR BAG fuse to fuse box.
8. Connect negative (-) cable at battery.
9. Turn ignition switch to ON position and verify that AIR BAG warning lamp flashes 6 times and then turns OFF. If it does not operate as described,
perform Air Bag Diagnostic System Check:Except Advanced Air Bag. See: Air Bag Systems/Testing and Inspection/Component Tests and
General Diagnostics/Diagnostic Strategies/Without Advanced Air Bag/Air Bag Diagnostic System Check
