Aerio L4-2.3L (2006)
vi. Place wheel-installed tire (4) with seat belt pretensioner (2) on ground in step v).
Wire harness specifications
Stripped wire harness section 1.25 sq.mm (0.0019 sq.in) or more (Stripped wire harness diameter 1.25 mm (0.05 in.) or more)
NOTE: Wind wire harness (3) around at least 3 times.
7. Stretch deployment harness (A) from air bag (inflator) module or seat belt pretensioner to its full length 10 m (33 ft).
Special Tool
(A): 09932-75031
8. Place 12 volts vehicle battery (1) near the shorted end of deployment harness (A).
9. Check that area around air bag (inflator) module or seat belt pretensioner is clear of all people and loose or flammable objects.
10. Connect adapter cable (B) or (C) as follows.
Special Tool
(B): 09932-76510
(C): 09932-78332
a. For driver air bag (inflator) module Check that driver air bag (inflator) module is placed with its vinyl trim cover facing up, and connect
adapter cable (B) to driver air bag (inflator) module.
b. For passenger air bag (inflator) module Check that passenger air bag (inflator) module is firmly and properly secured on deployment fixture
(special tool), and connect adapter cable (B) to passenger air bag (inflator) module.
c. For side air bag (inflator) module Verify that side air bag (inflator) module is firmly and properly on deployment fixture (special tool), and
connect adapter cable (B) to side air bag (inflator) module.
d. For seat belt pretensioner:
i.
Connect adapter cable (C) to seat belt pretensioner.
ii. Pile 2 wheel-installed tires (2) on top of tire with seat belt pretensioner (3), and tie them with wire harness (4) as shown.
Wire harness specifications
Stripped wire harness section 1.25 sq.mm (0.0019 sq.in) or more (Stripped wire harness diameter 1.25 mm (0.05 in.) or more)
NOTE: Wind wire harness around at least 2 times.
iii. Drape blanket (5) over those tires.
