Aerio L4-2.3L (2006)
WARNING:
-
For handing and storage of seat belt pretensioner (1), select place where ambient temperature below 65 degrees C (150 degrees F),
without high humidity and away from electric noise.
-
Never carry seat belt pretensioner (1) by wire or connector of seat belt pretensioner (1).
-
When placing seat belt pretensioner (1) on workbench or other surface, be sure to lay it with its exhaust hole (2) side facing up. It is
also prohibited to put something on seat belt pretensioner. Otherwise, personal injury may result.
6. Set air bag (inflator) module or seat belt pretensioner as follows.
a. For driver air bag (inflator) module
i.
Clear space (3) on ground about 185 cm (6 ft) in diameter where driver air bag (inflator) module (1) for deployment. Paved, outdoor
location where there is no activity is preferred. If outdoor location is not available, space on shop floor where there is no activity and
provide sufficient ventilation. Ensure no loose or flammable objects are within deployment area.
ii. Place driver air bag (inflator) module (1) with its vinyl trim cover facing up (2) on ground in step i).
b. For passenger air bag (inflator) module
i.
Clear space (3) on ground about 185 cm (6 ft) in diameter where passenger air bag (inflator) module (1) for deployment. Paved, outdoor
location where there is no activity is preferred. If outdoor location is not available, space on shop floor where there is no activity and
provide sufficient ventilation. Ensure no loose or flammable objects are within deployment area.
ii. Place deployment fixture (A) on ground in step i).
Special Tool
(A): 09932-75041
iii. Fill plastic reservoir in deployment fixture (A) with water or sand. This is necessary to provide sufficient stabilization of fixture during
deployment.
